1
3
4
5
INSTALL THE LENS RETAINER.
Remove the two front
assembly screws and remove the retainer. Adjust the projector
lens shift to
center the projector lens.
vertically and horizontally
Squeeze the retainer and work it into the projector opening to
nest into the inside rim of the projector housing with
prongs toward
the ceiling
bottom ridge aligned with the projector bottom-
and
front rib
. Tighten the retainer screws just enough to prevent rotation.
INSTALL THE DCR LENS.
After removing the rear DCR lens
cover, install the DCR lens/mount assembly over the retainer
prongs. Insert and tighten the two assembly screws to secure
(
).
do not over tighten
Remove the front protective film.
ADJUST THE LENS TILT AND PROJECTOR SHIFT.
Adjust
the projector lens zoom to fill the width of the screen with the
2.4:1 movie. Tilt the DCR lens and adjust the projector vertical
lens shift to make sure the beam is getting through the DCR
lens to fill the screen. There is only a slight variation in vertical image
height with this adjustment but experimentation may lead to the best
image fit and geometry. Lock the DCR lens tilt by tightening the single
Phillips tilt lock screw (
).
do not over tighten
DCR-S4 Installation Steps
Assembly
Screws
Tilt Lock
Screw
Bottom Ridge
Prongs to
Ceiling
www.panamorph.com
PREPARE THE PROJECTOR.
Adjust the projector roll, tilt
and/or yaw so the projector test pattern lines are square to the
screen edges. Adjust the vertical lens shift so the test pattern is
centered on the screen. Now
instead of
show a 2.4:1 movie
the test pattern. Set the Sony anamorphic lens menu setting to
1.32x
for a 2.25:1 screen or 1.24x for a 2.4:1 screen. Set the Sony Aspect
button on the remote to
.
V-Stretch
DECIDE HOW TO WATCH 16:9 CONTENT
(including menus).
Use the Sony “Aspect” button to select
(anamorphic
Squeeze
to 1.24x) to watch 16:9 content in the screen center, or
Normal
to stretch 16:9 content to fill the entire screen width. On a 2.4:1
screen zoom down the image to avoid cropping the top and bottom.
