3
4.
Once you have the projector properly aligned with the screen, CAREFULLY loosen the
Quick-Disconnect thumb nuts and allow the projector/mount to drop down until there is
enough space between the top and bottom halves of the projector mount for the CV
Mount to fit in between them. A second person is recommended to lightly hold the
projector and stabilize it.
5.
Swing the CineVista lens bracket all the way in so that it is close to the projector. Then,
bracing the projector from the back, insert the CineVista mount between the top and
bottom halves of the Chief mount and slide it back until the back edge of the lens
bracket rests 1/2” from the front of the projector’s lens or the front of the projector body
(whichever is closest to the CineVista lens).
6.
To help insure that an adequate distance is obtained a foam “spacer”(h) is included in
the installation kit. Place this spacer along the front of the projector and slide the CV
Mount into place until the back of both arms of the CV Lens Bracket touch the spacer
evenly.
7.
Tighten the Quick-Disconnect thumb nuts to stabilize the unit. Check to make sure the
projector is still properly centered on the screen and the top and bottom of the image
aligns with the screen. Adjust the image if necessary.
