INSTALLATION
B LT
Blue
®
B LT
Blue
®
B LT
Blue
®
B LT
Blue
®
B LT
Blue
®
B LT
Blue
®
5.
If the
NETWORK / DEMAND
RESPONSE
light is
RED
, the MD2-ZB
is not connected to a ZigBee network.
Proceed to step 6, SETUP.
6.
Verify that a BlueBOLT
®
device (BB-ZB1
or another MD2-ZB) is powered on and within
100 ft. of that active BlueBOLT
®
device.
1
.
Turn
OFF
the equipment that you are
plugging into the MD2-ZB
2.
Plug MD2-ZB into the wall outlet. The
red
WIRING FAULT
light indicates an im-
properly wired outlet that must be checked
by a qualified electrician.
4.
Press the
OUTLET 1
and/or
OUTLET 2
buttons to switch power on the respective
outlets.
8.
On MD2-ZB, press and hold the
OUTLET 1
and
OUTLET
2
buttons simul-
taneously until the
NETWORK / DEMAND
RESPONSE
light blips / blinks / flashes,
approximately 4 seconds. The
NETWORK/
DEMAND / RESPONSE
light will turn
GREEN
once it has joined the network.
7.
Through the BlueBOLT
®
interface,
enable JOINING. Refer to the user manual
for BB-ZB1 for detailed instructions.
3.
Plug your equipment into the AC outlets.
SETUP
OUTLET 1
WIRING FAULT
NETWORK DEMAND RESP.
OUTLET 2
OUTLET 1
OUTLET 2
NETWORK CONNECT
PUSH BOTH
SIMULTANEOUSLY
Multiple MD2-ZB units can be installed within 100 ft. from an active device (BB-ZB1 or another active MD2-ZB).
BB-ZB1
MD2-ZB
MD2-ZB
MD2-ZB
OUTLET 1
WIRING FAULT
NETWORK DEMAND RESP.
OUTLET 2
OUTLET 1
OUTLET 2
NETWORK CONNECT
PUSH BOTH
SIMULTANEOUSLY
OUTLET 1
WIRING FAULT
NETWORK DEMAND RESP.
OUTLET 2
OUTLET 1
OUTLET 2
NETWORK CONNECT
PUSH BOTH
SIMULTANEOUSLY
OUTLET 1
WIRING FAULT
NETWORK DEMAND RESP.
OUTLET 2
OUTLET 1
OUTLET 2
NETWORK CONNECT
PUSH BOTH
SIMULTANEOUSLY
100 ft. Maximum
100 ft. Max.
100 ft. Maximum
MD2-ZB requires BB-ZB1 Gateway (sold separately).
www.panamax.com www.mybluebolt.com