Panacom PA-7262, Руководство пользователя

Страница: 4 / 16

Pg. 4
3). Anti-parallel switch: Press “SET” button, press “53”, LCD will dis-
play “DEFEND OFF”, and “OFF” flash, then you can use
“ ” or “ ” button to select on or off, press “SET” to confirm.
3. Local code setting
Press “SET” button and press “6”, LCD will display “1-LOC- - 2-OL”,
and “- - -“ flash, select “1” to enter local code setting, then input the
local code. This phone can set 8 digits local code, if you set the lo-
cal code, the local incoming call number will not include local code;
Select 2 enter out of range code setting, LCD will display OUT OFF,
press “ ” or “ ” to input out of range code , the setting mode is
the same as setting local area code. If want to cancel out of range
code, press “ ” or “ ” to select “OFF”
Note: Out of range code only used for virtual net and small PBX us-
ers, and the direct line users can not setting.
4. LCD brightness adjusting
Press “ET” button, then press “7”, LCD will display “LCD CON 4”,
and “4” flash ( total 5 levels, default as the Forth one), you can press
“ ” or “ ” to select, press “SET” to confirm.
Making a call
Pick up the handset..Wait for dial tone. Dial the phone number. When
finished, press button again or put back the handset to hang
up after 13s.
Receiving a call
When phone rings. Pick up the handset. press button, when
finished, put back the handset to hang up.
Reviewing the incoming and outgoing calls:
To review the incoming calls by pressing “ ” or “ ”.
To review the outgoing calls by pressing “Check” key continually.
Press “REDIAL” to dial the selected number.
5. Function key operation
DELETE button -Press “DEL” to delete the selected number when
reviewing the incoming or outgoing calls. Press and hold this key for
3 seconds to delete all the incoming or outgoing calls. When dialing