16 170311R2
13.
(In case of using Cigarette socket jack) after completing the “safe back home” mode, the “Parking
mode” will be started and save the video record during preset parking tim
e.
14.
If the new version of firmware is detected on the SD memory card, the upgrade will be started after the
voice command. During the upgrade process, the 4 LEDs will be blinking as followings. After
completing the firmware upgrade, the voice command will notify you.
Voice command: “Start the upgrade process.”
-> “Complete the upgrade. Push the reset button”
15.
Start to adjust the X,Y,Z value of GPS signal.
- Turn of the engine after insert the SD memory card.
- Turn off the S1 power.
- The process will be started after the push the Emergency call button.
During this process the POWER LED will be blinking as followings.
This process will take about one minute.
P
lease keep this process on the flat plain location. If not, the X, Y, Z data of GPS may be distorted.
16.
The whole process is completed and the product is working properly.
17.
In the unlikely event if any problems are detected the voice command will request reset. Push a reset
button to restore and rectify Drive Recorder.
SD memory card folder and file
1.
Set up folder
- The required setup files are saved for the Plug 'n' Drive main system.
2.
Video folder
- The video data will be saved on the folder by the time.
- Folder name: Date_Time (DYYYYMMDD_HH
ex) 2009.03.15. 08:30AM D20090315_08
3.
Video file
- The video file will be saved by one minute unit.
- File name: Date_HrMinSec.extension
(YYYYMMDD_HHMMSS.esf/YYYYMMDD_HHMMSS.sub
ex) OUT camera (forward side) : 20090303_083040.esf
IN camera (rear side) : 20090303_083040.sub
When the SD memory capacity is full?
1.
Save video folder to PC/Laptop or CD and delete video folder.
2.
Alternatively PNGD will automatically delete oldest files first to recover space for new recordings.
Safely removing SD memory card
1.
Turn off the system main power button.
(The system power can be turned off during the parking mode.)
2.
Check the LED light status – all LED light should be off.
3.
Remove the SD memory card from the main system.
4.
Follow the above process (1.2.3) at the parking mode too.
5.
After saving the data, insert the SD memory card back into the PNGD. The PNGD will not record
without the SD card, LED's will be flashing.
