Palstar ZM-30, Руководство пользователя

Страница: 23 / 37

23
5. Connect your ZM-30 to the PC using a
standard, straight-through male-female
DB9-type serial cable. Do not use a null
modem cable that swaps pins 2 and 3
from end-to-end.
6. If not already running, make sure that
TeraTerm (or some other terminal
program) is running on your PC.
7. Power-up the ZM-30 again by plugging
in the external power cable, or by
inserting the battery that was previously
removed.
8. You should immediately see the HCmon
program display its sign-on message to
the PC screen.
9. Proceed as before in steps 5-11 above,
copied below for easy reference …
a.
Type
C
to clear out memory. See
the C character echoed to the screen
and the HCmon> prompt displayed
again.
b. Type
L
to load new program. See
message “…waiting …”
c. Pull down the File Send File
menu.
d. Navigate to where you saved the
*.s19 file
e. Once in the folder that contains
zm30vXXX.s19
file, select that file
and click the Open button. (Be
careful to only load S19 files! If you
mistakenly select any other file
extension, it is very likely that you'll
mess up the bootstrap loader
program.)
f. See line after line of ASCII data
displayed in short one-second bursts.
This will continue for about 2
minutes until the entire program has
been sent to the ZM-30 and has been
flashed into its memory. DO NOT
INTERRUPT THIS PROCESS!!
When it is complete, the
HCmon >
command prompt will be displayed
again.
g. Type
X
to exit the HCmon program
and the ZM-30 will power down.
10. Disconnect the serial cable.
11. Remove the two jumpers.
12. Re-install the case.
13. Power the ZM-30 on again with the
On/Off pushbutton to start the newly-
loaded program. You will see the new
version number presented in the LCD
sign-on message.