Palsonic VCR6200HS, Руководство пользователя

Страница: 6 / 32

To the TV via antenna cable (if you are not using RCA cable)
4
If you are using a RCA cable, select the AV input on the TV to see the picture from the video.
If you are not using a RCA cable, select the button number on the TV reserved for video input to see the picture from
the video.
If you are not using a RCA cable, your video can transmit pictures and sound to the TV via the coax aerial cable.
Just tune the TV to the video's transmitting channel (factory set to UHF CH 36). Tune the TV carefully to ensure
the best pictures and sound.
Once you have carried out the steps in "Setting up your
video" (previous page), switch on your TV.
When you install your VCR first time.
Press button of the video's remote control.
Tune the TV to the 'LANGUAGE SET' using the channel
preset functions of your TV as described in its manual.
When you install your VCR more than two times. (It
means you already done the procedure of P.6 'Tuning
the TV').
Press button of the video's remote control.
Tuning the TV to the blue-back screen, if you found blue
back screen on the TV then press MENU button on your
video's remote control and confirm 'MAIN MENU' screen
is appeared, if not tuning the TV again.
Once you have found the picture of above two cases,
follow this instructions within your television manual to
store this new channel into a programme location.
If the quality of the test picture transmitted to the TV is poor due to interference caused by a station transmitting on
channel 36, you can tune the video to a different transmitting channel. Find a free channel between 21 and 69 on your TV.
Call the video's "MAIN MENU" choose
"VCR SETUP" then "RF OUTPUT SET".
Type in the free channel.
Store and exit.
If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help
(refer to the TV manual).
Without a RCA cable , you will not get stereo sound from a TV capable of stereo sound.