RADIO OPERATION
Set the FUNCTION switch to RADIO position
FM
Select the FM or FM STEREO by BAND SELECTOR switch. Turn the TUNING knob to select the
required station. The FM stereo LED indicator will light on when a stereo broadcast is being
received Fully extend the FM antenna and adjust its direction for best FM reception.
AM
Select AM by BAND SELECTOR switch. Turn the TUNING knob to select the required station. For
operation on AM the set contains a built-in ferrite aerial which is directional. Therefore, the set
should be positioned for the best signal strength.
Connect the FM Antenna
Connect the FM antenna wire to FM 75-ohm terminal, OR, For better FM reception, use of an 75 ohm
outdoor antenna is recommended, connect the 75 ohm outdoor antenna to FM 75 ohm terminal.
CASSETTE OPERATION
Set the FUNCTION switch to TAPE position.
Playing Of Cassette
Be sure to tighten any slack tape in the cassette before use, using either a pencil or a ball-point
pen, simply insert the pen or pencil into the centre of the spool and rotate to remove the slackness.
Depress the CASSETTE STOP / EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing downwards and the full reel on
the left hand side, push the cassette well down and close the door, be sure not to touch the tape
surface. To play the cassette, press the CASSETTE PLAY button. For brief interruptions, press the
CASSETTE PAUSE button on the unit. To continue playback, press the CASSETTE PAUSE button
again. To stop playback, press the CASSETTE STOP / EJECT button once. To release the cassette,
press the CASSETTE STOP / EJECT button again.
Winding the tape
Press CASSETTE F.FWD button to fast-forward the tape.
Press CASSETTE REWIND button to fast-rewind the tape.
Press CASSETTE STOP / EJECT button
to stop fast-forward or fast-rewind, before the
end of the tape.
When the tape reaches its end after fast winding, you must press CASSETTE STOP
/ EJECT button
to release CASSETTE F.FWD / REWIND button
Recording From Radio
Set the FUNCTION switch to RADIO and select AM or FM by BAND SELECTOR switch. Tune to the
desired broadcast (refer to radio operation section). Insert a blank cassette into the deck and
press the CASSETTE RECORD button (together with the CASSETTE PLAY button). Press the
CASSETTE STOP / EJECT button to stop recording The CASSETTE PAUSE button can be used
to stop recording for short intervals.
Note :
If beat noise is present when recording adjust the position of the BEAT CUT switch on
the rear of the unit (For AM only).
Recording From CD
Set the FUNCTION switch to CD Select the required tracks to be recorded. Insert a blank
cassette into the cassette deck and press the CASSETTE RECORD button (together with the
CASSETTE PLAY button) Press the CASSETTE STOP / EJECT button to stop recording.
Note :
The volume level and the BSS function has no effect on the content of recording.
3
.
.
.
.
Содержание PMC-211
Страница 2: ...14 Ib z b 21 h 23 2 4 n...
