18
Getting Started
Step 8. Install Remote Control battery and Universal Code
setting.
Install Remote Control battery. The battery has polarity so when insert the batteries
make sure the "+" and "-" terminals are oriented correctly. The mode selection,
buttons are TV, VCR. DVD and STB. You can change the code of other CE component
with this mode button. For more detailed information, please refer to the Remote
Control Universal Code Setting section.
Step 9. Check up the On Screen Display.
For verify correct setting of Display Mode, you should check up the OSD from HDTV's
display screen.
Turn on the HD-STB and HDTV. Press Menu button on the remote control, you should
check up the OSD for verify A/V connection. If you cannot find any OSD in your TV
display, please check up again the Display Mode Setting and A/V connection.
Step 10. Automatic Channel Search and Channel Change.
Please set the time Zone and perform the Automatic Channel Search to find possible
channels. Please make sure, you should wait until fully searched. Normally, it will take
several minutes.
If you setting up the favourite channel using Favourite Setup in the menu system, you
can change the channel using "CH+" or "CH-" between selected favourite channels.
Please make sure in favourite channel mode, the channel change operation is based on
Favourite Setting in the internal memory. If you unmark the channel in the favourite
list, you cannot access the channel using "CH+ of "CH-" button. At that time, please
perform the Favourite Setup and mark the Channel in the favourite list.
