PALSON Sky Plus, Руководство по эксплуатации

Страница: 10 / 25

18 19
GB
NOTE:
The floor brush comes with a separate connector for packaging
reasons.
Assemble the connector as shown in the picture.
Adaptor for accessories
The steam cleaner has very different nozzles for cleaning different surfaces more efficiently and thoroughly.
First assemble the accessory adaptor (4) to be able to connect them to the steam hose. The steam adaptor
can be directly connected to the steam gun and to the end of one or more extension tubes.
Check that the adaptor is firmly pushed down until it clicks into
position (Fig. 10).
Push the right release button and move it away downwards to remove
the adaptor again (Fig. 7).
Brush and nozzles
The accessory adaptor (8) can be used only
for cleaning or also connected to one of the
nozzles with a brush, the jet nozzle and the
window accessory.
Push the nozzle onto the accessory adaptor
and firmly turn it a quarter way around in the
direction of the arrow on the nozzle (Fig. 11).
Follow the same procedure the other way
around to remove the nozzle for corners.
Turn the nozzle a quarter of the way round in the opposite way to the arrow and pull it downwards to remove it.
Nozzle for corners
You just have to firmly push the accessory adaptor onto the nozzle
for corners to connect it. (Fig. 12).
This nozzle allows thoroughly cleaning hard to reach areas such as
corners, joints and toilets easily. The corner nozzle can be removed
by pulling it downwards.
Nozzles with brushes
The two accessory brushes are firmly pushed onto the accessory adaptor in the same way as the jet nozzle.
Even the most encrusted dirt can be removed, for example, on blinds, central heating radiators, valves, etc.,
with the small nylon brush (Fig. 13).
Steam hose
First connect the steam hose to the steam plug on the front of the cleaner. To do so, open the cover and push
the steam hose connector firmly inside the steam plug unit it clicks into position (Fig. 4).
To remove the steam hose, push the two release buttons on the right and left-hand side of the steam connector
to remove the steam plug (Fig. 5).
Extension tubes
Assemble the extension tubes if you are going to use the steam cleaner for cleaning floors or hard to reach
areas. To do so, push the open end of the tube into the steam gun. Push it into the steam gun until the gun’s
release button clicks into position (Fig. 6). Put one, two or three extension tubes on if necessary.
Push the right release button and stretch the tubes to move them away pulling them down to remove the
extension tube again (Fig. 7).
Floor brush
Attach the floor brush to the end of the extension tube. Check that the brush clicks into position (Fig. 8).
The floor brush is perfect for cleaning wall and floor linings. It can be used with or without the cleaning cloth.
However, we recommend using the cloth to protect linings in the case of sensitive surfaces such as wood. Put
the floor brush on the cleaning cloth and fasten the surplus material underneath the staples of the cleaning
cloth on the left and on the right. Push the inside sides of the support, open the staples and then fasten the
cleaning cloth into place (Fig. 9).
To remove the floor brush, push the right release button (Fig. 7) and pull the brush downwards to remove it.