10
BENTO 42 CORTEN FIRE PIT Match-lit | Installation & Owner's Manual
OPERATING INSTRUCTIONS
Use only your hand to push in or turn the gas control key. Never use tools. If the key will not push in or turn by hand, don’t try
to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
1. Turn the gas control key to the OFF position (it will be necessary to depress the key slightly at the PILOT position). Allow
five minutes for any gas in the vicinity to dissipate. (LP gas, which is heavier than air, may require forced ventilation).
2. Turn the gas control key to the PILOT position.
3. Push down on the gas control key and light the pilot immediately by applying a flame to the lighting port. Hold the key
down for one full minute after lighting the pilot.
4. When the gas control key is released, the pilot flame should continue to burn (if the pilot goes out, repeat the above steps).
5. Rotate the gas control key from PILOT to ON position (full counterclockwise position) to supply full flow to main burner.
NOTE: Not turning the gas control key to the full ON position will reduce the flow and could result in poor ignition of main
burner.
6. To extinguish main burner, rotate the gas control key clockwise to the PILOT position.
7. To extinguish pilot, depress control key slightly and turn to the OFF position (fully clockwise).
LIGHTING YOUR FIRE PIT
STOP!
Review the safety
information on pages 1, 2
and 8 of this manual.
90°
PILOT
FULL PUSH TO LIGHT
ON
OFF
SLIGHT PUSH TO TURN OFF
90°