PaloAlto Networks PA-220R, Справочник по аппаратуре

Страница: 22 / 40

Install the PA-220R Firewall
Install the PA-220R Firewall on a Wall
The following procedure describes how to install the PA-220R firewall on a wall using the wall-
mount kit.
You can purchase the wall-mount kit separately from the
Palo Alto Networks Sales Department or
an authorized reseller.
STEP 1 | Idenfy the locaon where you will install the firewall and ensure there are no building
services (water, gas, or wiring) behind the wall.
STEP 2 | Aach the wall-mount bracket to the boom of the firewall using four 6-32 x 1/4” Phillips-
head screws and torque each screw to 9 in-lbs.
STEP 3 | Use a Phillips-head screwdriver to install the appropriate hardware to mount the firewall to
the wall based on the wall type:
To ensure proper heat dissipaon, install the firewall so that the front panel (with ports
and LEDs) faces either le or right.
• Drywall —First hold the firewall up to the wall where you will install it and use a sharp object
to mark the wall behind the center of each of the four wall-mount bracket holes. Remove
the firewall and press a drywall anchor into the center of each of the four locaons you
marked and use your screwdriver to apply pressure while turning the anchor clockwise unl
PA-220R Next-Gen Firewall Hardware Reference 22
©
2021 Palo Alto Networks, Inc.