PaloAlto Networks PA-220R, Справочник по аппаратуре

Страница: 14 / 40

PA-220R Firewall Overview
PA-220R Front Panel
The following image shows the front panel of the PA-220R firewall and the table describes each
front-panel component.
Item Component Descripon
1 Screw-on ground point Use this ground point to connect the firewall to
earth ground (ground cable not included).
2 DC power and ground inputs Use the DC input terminal block to connect DC
power to the firewall. The terminal block is included
in the accessories kit and is labeled A+, A-, B+, and
B-.
The two inputs to the right of the four DC power
inputs are ground inputs (use only one) that you can
use in place of the screw-on ground point on the
firewall (see Connect Power to a PA-220R Firewall ).
3 Ethernet ports 1 through 6 Six RJ-45 10Mbps/100Mbps/1000Mbps ports
for network traffic. You can set the link speed and
duplex or choose auto-negoate for each port.
These ports also have built-in surge protecon.
4 SFP ports 7 and 8 Two SFP (1Gbps) ports for network traffic.
These ports also support 100Base-FX.
5 MGT port Use this Ethernet 10Mbps/100Mbps/1000Mbps
port to access the management web interface and
perform administrave tasks. The firewall also
uses this port for management services, such as
retrieving licenses and updang the threat and
applicaon signatures.
6 CONSOLE port (RJ-45) Use this port to connect a management computer to
the firewall using a 9-pin serial-to-RJ-45 cable and
terminal emulaon soware.
PA-220R Next-Gen Firewall Hardware Reference 14
©
2021 Palo Alto Networks, Inc.