PaloAlto Networks ION 7000, Справочник по аппаратуре

Страница: 25 / 30

Install the ION 7000
Install the ION 7000 in Virtual In-Path Configuraon
The ION 7000 uses a virtual in-path concept to allow the system to perform SD-WAN operaons
on as it enters and exits the data center. This mode of operaon allows the ION 7000 cluster to:
• Solicit very specific traffic for specific endpoints using tradional network roung protocols.
• Require lile or no changes in the exisng data center network topology.
• Horizontally scale based on load and site number and geographic distribuon.
• In event of failure, seamlessly transion traffic to another ION 7000 or the legacy roung
network.
The following figure illustrates the virtual in-path deployment architecture of an ION 7000 data
center.
To set up the ION 7000 virtual in-path deployment, configure the system with the following port
types:
•
Setup the ION 7000 Controller Port
• ION 7000 Peering Ports
• ION 7000 Internet Ports
If the ION 7000 is DHCP-enabled, no addional configuraon is required. If the device is not
DHCP-enabled, you need to configure the device using the stac IP address .
Setup the ION 7000 Controller Port
The ION 7000 uses the controller port to communicate with the controller and monitor the
network. By default, DHCP is factory-configured on this port. The controller 1 port should be
ION 7000 Hardware Reference 25
©
2021 Palo Alto Networks, Inc.