PaloAlto Networks ION 7000, Справочник по аппаратуре

Страница: 23 / 30

Install the ION 7000
Install the Slide Rail into the Rack
Install the slide rail into a standard 19 inch rack as described below:
STEP 1 | Select a 1-U slot to insert the slide rail into a standard 19-inch rack.
STEP 2 | Snap the three (3) square pegs of the rail into the front and back mounng plate of the rack.
STEP 3 | Ensure that you fully engage the spring retenon clip so that the rail is securely aached to
the mounng plate.
If the rack has square holes:
1. Insert the slide rails into a standard 19-inch rack making sure that the rails snap into
place.
2. Aach the chassis-mounng brackets to either side of the ION 7000.
3. Slide the ION 7000 into the rack and confirm that the device is installed securely in the
rack.
If the rack has threaded round holes:
1. Unscrew and detach the square rail snap ends from both ends of each rail.
2. Using screws that fit the threads of the rack (not included), aach each end of the rail to
the rack.
3. Aach the chassis-mounng brackets to either side of the ION 7000.
4. Slide the ION 7000 into the rack and confirm that the device is installed securely in the
rack.
If the rack has unthreaded round holes:
1. Insert the rail as sent behind the hole plate.
2. Using screws that fit the threads of the rail (not included), screw through the hole in the
plate to the screw holes on the end of the rack (from the front).
3. Aach the chassis-mounng brackets to either side of the ION 7000.
4. Slide the ION 7000 into the rack and confirm that the device is installed securely in the
rack.
ION 7000 Hardware Reference 23
©
2021 Palo Alto Networks, Inc.