Hand Dryer
Operating Instructions and Parts Manual
Surface-mounted high speed hand dryer
Installation
1. Make sure power supply breaker is switched off. Installation must be carried out in
accordance with the current edition of the local wiring regulations code having
jurisdiction. Installation should be performed only by a qualified electrician.
2. Place template against wall at desired height (see mounting height recommendations)
and mark locations of 4 mounting holes and wire service entry at knockout (KO) location.
Note:
For two or more dryers, dryers should be no closer than 24 inches (610 mm)
on center.
1.
Remove and retain 2 cover screws
and cover.
2.
Insert the power cord into the
opening.
4.
Fix the base plate to the wall with 4
screws of 1/4 x 1-1/2
"
dimension.
5.
Put the front coverbackand screw
it with L key.
3.
Connect supply wires to terminal block:
Connections:
A. Connect the live wire (black or dark color)
to the terminal block marked "L".
B. Connect the neutral wire (white or light color)
to the terminal block marked "N".
C. Connect the ground wire (colored green or green and yellow)
to the green screw marked " ".
Note that colors of live and neutral wires depend
on voltage of supply service.
3
HandDryerSupply.com | 804-859-2498 | [email protected]
