Pall WandMixer RDUA003A, Руководство оператора

Страница: 15 / 20

Document #: 5100000 Revision: C
Page #: 15 of 20
6.5 Position the mixing bag with retaining tank in such a way that fitting with coupler is
located approximately under the shaft adaptor ( see Figure 10, below ).
6.6 Adjust vertical position of the motor by rotating the handle of the motor positioner
until the distance between the coupler and the shaft adaptor is about 2 inches.
6.7
Hold the coupler, move it toward the shaft adaptor, insert the hex head of the wand
in the receiving hex cavity inside the adaptor, bring the mating surfaces of two flanges
together (
see Figure 10, below ).
6.8
Secure the flanges of the coupler and shaft adaptor against each other by clamp
( see Figure 10, below ). Tighten the screw on the clamp.
6.9 Move the motor coupled with the bag slightly up by turning the handle of the
motor positioner until noticeable bag tension is developed
.
Figure 10:
Sequence of steps to connect mixing bag with drive motor
e -drive motor, f -shaft adaptor, g -clamp