Palfinger V 1000 LQ, Инструкция по монтажу

Страница: 20 / 34

16
FITTING DROPPERS
•
Position the droppers on either side
of the chassis ensuring that they are
vertical. Ensure that the flanges of
the dropper are up against the plates
which come welded to the under run
bar (See Figure 1) The droppers are
designed for a range of vehicle floor
heights. If desired they can be
shortened by removing material from
the bottom of the dropper. When
satisfied that the droppers are
positioned correctly mark the chassis
using the pre-drilled holes in the
dropper
and drill the chassis.
Assemble the droppers to the chassis
using the 12 off - M16 x 40 bolts
provided. With droppers in position
drill through the under run bar plates
and dropper flanges and secure with
4 off - M12 bolts provided.
Figure 1
Torque settings for:
M16 x 40 = 315 Nm
M12 x 40 = 85 Nm
•
Select the appropriate position for the
horizontal braces. Bolt to the droppers
with the 4 off - M12 bolts supplied. To fit
the dropper to the chassis follow the
sequence detailed in the section ‘Fitting
Drop arms When attaching the brace to
the under run bar drill through the under
run bar plates and brace end plate and
secure with 4 off - M12 bolts provided
(See Figure 3) You must ensure the bolt
is positioned centrally through the brace
end plate. (See Figure 2)
Figure 2