Palax C700 COMBI, Руководство по эксплуатации

Страница: 34 / 39

30
translation
7.14 Adjustment of launch bar clearance
The value for rough adjustment is about 34 mm (Figure 36).
Fine adjustment:
1. Loosen lock screw B on the shaft (17 mm spanner, Figure 36).
2. Turn control lever E so much that clearance A (Figure 35) of about 3-4 mm is
formed between the front edge of the square hole and launch rod D.
3. Lock the screw.
7.15 Conveyor transmission, Fig. 37
The conveyor is equipped with hydraulic transmission
7.16 Conveyor chains, Fig. 38
When operated continuously, the conveyor chains should be lubricated daily.
The easiest way to do this is to apply chain spray lubricant to the chain while the
conveyor is rotating at low speed.
The chain only requires light daily lubrication.
When the machine is left standing for longer periods, it pays to lubricate the chain
properly to prevent rust. The sliding sleeves for the chain-tighteners must also be
lubricated lightly.
The bearings of the conveyor are lubed-for-life so they do not require any
maintenance.
37
Fig. 37. Conveyor transmission
38
Fig. 38. Conveyor chains
7.17 Cleaning the machine
Keep the conveyor free of debris to ensure its trouble-free operation.
Especially in winter, it is important that the conveyor is always cleaned at the end
of every working session.