paladin Sweepster CTM4800, Руководство оператора и каталог запасных частей, Страница: 49 / 62

49
51-3000
OPTION - DIRT DEFLECTORS
Installation
1. Clamp the extension plate to the front of the
hood, centered from left to right. The top edge
of the extension plate must be 2 inches (51mm)
from the bend in the hood.
2. Transfer punch holes from the extension plate to
the hood. Remove the extension plate and drill
holes with a 13/32 inch bit.
3. Place the rubber flap and then the retainer plate
on the bottom edge of the extension plate. Insert
3, 5/16-18 x 1 inch carriage bolts in the middle 3
holes. Secure with lock washers and nuts.
4. Attach the extension plate to the hood with 5,
3/8-16 x 1 inch cap screws, lock washers and
nuts. Do not tighten the hardware.
5. On one side of the sweeper, remove the front
screw that secures the hood to the brush frame
(figure 1). Secure the extension bracket to
the brush frame with hardware just removed.
Repeat on the other side of the sweeper.
6. On both sides of the sweeper, attach extension
brackets to the outside holes in the extension
plate and flap assembly. Use 2, 5/16-18 x 1 1/4
inch carriage bolts, lock washers and nuts.
7. Tighten all hardware.
figure 1