Pai Technology Botzees Go! Dino, Инструкция по эксплуатации

Страница: 4 / 28

Note: This step must be done under adult supervision, or completed by an adult.
Indicator Light
Main control block
indicator light
Please read this no�ce before using this product.
Ba�ery installa�on and replacement: You will need two (2) 1.5v AA ba�eries, two (2) 1.5v AAA ba�eries
and a cross head screwdriver. (Ba�eries and screwdriver are not included in the package).
Install the main control block ba�eries
-Use a cross head screwdriver to unscrew the bo�om
screws counter-clockwise and remove the ba�ery
cover.
-Insert two (2) 1.5v AA ba�eries in the direc�on
indicated inside the ba�ery compartment.
-Replace the ba�ery cover and screw clockwise to
fasten with a screwdriver.
-Press the bu�on at the bo�om. The main control block
indicator lights will flash if you have installed the
ba�eries correctly.
Install the remote control ba�eries
-Use a cross head screwdriver to unscrew the bo�om
screws counter-clockwise and remove the ba�ery cover.
-Insert two (2) 1.5v AAA ba�eries in the direc�on
indicated inside the ba�ery compartment.
-Replace the ba�ery cover and screw clockwise to fasten
with a screwdriver.
Sync the Remote control
-Make sure the red indicator light in the front has started to flash a�er
installing the ba�eries.
-Turn on the main control block. Then press any bu�on on the
remote-control to sync with the main control block.
-If syncing is complete, the indicator light on the remote control will
automa�cally shut off. If the indicator light con�nues to flash for
another 30 secs, please re-sync.
If the remote control isn’t used for 20 minutes, the main control block
will go into standby mode. To use again, please press the bu�on at the
bo�om of the main control block.
How to Re-sync
If the remote control indicator light or main control block indicator light
flashes quickly, or the remote control is not able to control the main
control block, please restart the syncing process.
1. Remove the ba�ery covers of the main control block and the remote
control. Remove the ba�eries.
2. Re-install the ba�eries and put back the ba�ery cover.
3. When the indicator light on the main control block is flashing, press
any bu�on on the remote control to start syncing. A�er syncing is done,
the remote control indicator lights will turn off automa�cally.
FAQ
How can I tell if the ba�ery is almost
exhausted?
1: The speed is significantly slower
2: It gets stuck when moving/not enough
power
3: It cannot be turned on
What do I do if the main control unit does not turn on?
Please check to confirm:
1. Are the ba�eries exhausted? If ba�eries are exhausted,
please replace the ba�eries
2. Are the ba�eries installed correctly? Check the polarity of
the ba�eries; if installed incorrectly, please re-install the
ba�eries to ensure they match the required polarity
3. Is the power turned on? Please try again a�er powering
on the main control block
4. Has the remote control been synced with the main control
block? If they have not been synced, please have them
synced and then retry.
5. If there is s�ll a problem, please contact customer service.