Page 2 of 2
Rev. A
How to install your
T@B Clamshell Tent
by PahaQue
1.
First, locate the keder rails and remove adhesive covering.
Placement of keder rails should be 6” above hatch hinge. (Surface
must be clean and dry. Use rubbing alcohol or window cleaner.)
Line up keder rails so that they form 1 continuous channel across
trailer roof. Affix and press firmly. It’s best if keder rails are left
overnight to fully set before attaching tent.
2. Locate corner protectors and affix them to corners of clamshell
hatch as pictured. This is to protect the roof of the tent from the
sharp corners of the hatch.
2.
Next, insert keder cord on tent body into keder rail.
Photo A
3.
Next, locate and assemble both roof poles and insert into roof
sleeves. Beginning at the front, right side of tent (opposite the
trailer) Make sure leading edge of pole is fully seated into roof
pole sleeve. Next, insert trailing end of roof pole into plastic
elbow connector. Repeat for other roof pole.
4.
Next, locate and assemble both aluminum corner poles. Insert
open ends into elbow connectors from Step 3 and pegs into
grommets near ground. Photo D
5. Exact placement of the Velcro on the floor of the trailer for the
skirt varies and is at the users’ discretion. The skirt shouldn’t be
too tight to that it doesn’t pull of the Velcro when standing near it.
Remove adhesive backing from Velcro and affix to trailer floor as
shown.
6. Next, secure “C” clips to corner poles. Photo E
7. Lastly, using the included ground stakes, secure tent to ground
using all ground stake-down points along outside bottom edge of
tent.
!CAUTION!
The effects of wind and rain on the Tent are unpredictable. Damage to the trailer and/or Tent may result. Please remove the
Tent in heavy wind or rain. Damage due to weather is not covered by your warranty.
888-700-TENT / www.pahaquecustom.com
