29 Class 1
(safety earth). UK mains lead fitted
with 1" fuse to BS1362 rated 5A.
Operating Temperature Range:
0°C to +40°C (+32°F to +104°F).
Overall Dimensions (excluding PAGlok claws):
160 x 105 x 42mm (6.3" x 4.1" x 1.65").
Weight:
1.3lb (600g).
OPERATING INSTRUCTIONS
Power Supply Model 9791 is designed to
mount directly onto the back of equipment
that is fitted with a PAGlok battery connector.
The Power Supply is suitable for use with
either standard or System RTI models.
PAGlok connectors are available for most
cameras. If your camera is not yet fitted with
the PAGlok connector, please contact PAG or
your Dealer for the correct application. The
Power Supply is also available in models that
are compatible with the V-Mount and Anton-
Bauer battery connector systems.
Fit the Power Supply to the equipment and
connect the supply cord to the input socket.
Power up the unit and the green mains LED
will be lit.
The Power Supply has a nominal output
of 50W at 13V, which is sufficient to power
most popular models of camera. Ensure
that the combined wattage of the camera/
recorder and a lamp (if used) does not
exceed 50W.
The Power Supply will automatically detect
the presence of an excessive load, and limit
the output to a safe current level.
Do not obstruct the cooling fins that are
present on the rear of the unit. If the Power
Supply becomes overheated it will shut down
and no damage will occur. The protection
circuit will latch off, and can only be reset by
turning off the input supply. Allow the unit
to cool before continuing to operate.
The output is protected against over-voltage.
If the Power Supply produces an excessively
high voltage it will shut down and the circuit
will latch off as described above.
SERVICING AND REPAIRS
WARNING: To reduce the risk of electric shock,
do not attempt any servicing or repairs unless
you are qualified to do so. Refer all servicing
or repairs to qualified servicing personnel.
The Power Supply contains advanced electron-
ics that do not require periodic maintenance.
Consequently there are no user serviceable
parts inside.
Qualified electronics engineers who wish to
gain access to internal assemblies should
note that parts of the power circuit retain a
high voltage even after the supply has been
disconnected. Wait for a period of five
minutes following disconnection before
commencing disassembly.
When the Power Supply is correctly connected
to an AC supply and the green mains LED is
not lit, it is likely that a fault has developed.
Seek advice from your nearest PAG Dealer or
direct from PAG Ltd., London, by telephoning
+44 (0)20 8543-3131.
U4986 ISS B / 0011
