Pacojet Junior, Руководство пользователя, Страница: 32 / 233

27
EN
Attach the protective beaker (12) with the pacotizing
beaker (10) to the
Pacojet Junior
.
To do this, slide the upright protective beaker with
pacotizing beaker upwards into the rounded mold on
the base to center it 1 .
Start this step by making sure that the handle is
pointing to the right in the starting position and that
the top of the pacotizing beaker is flat on the device.
Turn the protective beaker from right to left
approximately 90° to the left until the stop in the
holder
2
.
The handle will point forwards when the protective
beaker is attached correctly.
7.
Press the START KEY (21). The rinsing cycle starts.
Remember that the device needs to be in “operating
mode” for this (see “START KEY” on page 13).
8.
During the rinsing cycle, you can press the
depressurization button (7) to rinse the depressurization
hose. To do this, press the depressurization button
while the pacotizing shaft (2) is moving up 1 . Make
sure that you hold a container at the end of the
depressurization hose in order to catch the rinse water
that sprays out 2 .
2
1
9.
At the end of the rinsing cycle (the motor stops),
remove the protective beaker (12) with the pacotizing
beaker (10).
To do this, turn the protective beaker approximately 90°
to the right 1 and slide it out at the bottom
2
.
The rinsing insert (13) and pacotizing blade (9) will be
attached to the protective beaker.
8.1.5 Cleaning cycle
Complete the following steps:
Rinsing cycle
Rinse the device as described in Chapter “8.1.4 Rinsing cycle” on page 25.