INSTALLATION GUIDE
FFLE Series LED Flood
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2021 PacLights All Rights Reserved
Page 2 of 3
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL_INST_FFLE_v0
FFLE FLOOD MOUNT
FIG. 5
BOLTS
FIG. 4
The FFLE Flood Mount drilling patterns (Fig. 3).
3
NUT
WASHER
WALL / SURFACE
HOLES
~
FFLE FIXTURE
The Flood Mount can be rotated. Loosen the Cap Head Screws (2)
and adjust the tilt angle of the FFLE fi xture to point towards the
desired location. Tighten the Screws to hold the FFLE fi xture in place
(Fig. 5).
5
FLOOD MOUNT
FFLE FIXTURE
SCREW
The Flood Mount can be mounted to a Wall/Surface. Align the Flood
Mount to the pre-drilled holes on the mounting surface and fasten
the fi xture to the wall (appropriate mounting Bolts, Washers, and
Nuts not included) (Fig. 4).
4
FIG. 3
FFLE - 200/240
FFLE - 100
FFLE - 150
WASHER
NUT
FFLE TRUNNION MOUNT
The Trunnion Mount is available for all FFLE fi xtures. If installed,
remove the Flood Mount by removing the the Cap Head Screws
(Refer to Fig. 2). Install the Trunnion Mount, Cap Head Screws, Lock
Washers, and Washers by aligning to the holes (4) at the base of the
FFLE fi xture (Fig. 6).
1
2
FIG. 6
FFLE FIXTURE
TRUNNION
MOUNT
FIG. 8
3
The FFLE Trunnion Mount drilling patterns (Fig. 7).
The Trunnion Mount can be mounted to a Wall/Surface. Align the
Trunnion Mount to the pre-drilled holes on the mounting surface and
fasten the fi xture to the wall (appropriate mounting Bolts, Washers,
and Nuts not included) (Fig. 8).
WASHER
FFLE - 100/150/200/240
FIG. 7
BOLTS
WALL / SURFACE
NUT
WASHER
HOLES
~
The Trunnion Mount can be rotated. Loosen the center Cap Head
Screws (2) and remove the smaller Cap Head Screws to adjust the tilt
angle of the FFLE fi xture to point towards the desired angle. Replace
the smaller Cap Head Screws and tighten all of the Cap Head Screws
to hold the fi xture in place (Fig. 9).
4
FIG. 9
SCREW
SCREW
FFLE FIXTURE
LOCK WASHER
FFLE FIXTURE
TRUNNION
MOUNT
