INSTALLATION GUIDE
FFHL Series LED Flood
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2021 PacLights All Rights Reserved
Page 2 of 4
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL_INST_FFHL_v0
FIG. 4
BOLT
FIG. 3
NUT
WASHER
WALL / SURFACE
HOLES
~
FFHL FIXTURE
The Trunnion Mount can be rotated. Loosen the center Cap Head
Screws (2) and remove the small Screws, Lockwashers, and Washers
at the sides of the FFHL fi xture. Adjust the tilt angle of the FFHL
fi xture to point towards the desired location. Reinstall and tighten
the Screws, Lockwashers, and Washers to hold the FFHL fi xture in
place (Fig. 4).
4
TRUNNION
MOUNT
FFHL FIXTURE
SCREW
The Trunnion Mount can be mounted to a Wall/Surface. Align the
Trunnion Mount to the holes pre-drilled on the mounting surface and
bolt the fi xture to the wall (appropriate mounting Bolts, Washers, and
Nuts not included) (Fig. 3).
3
FFHL TRUNNION MOUNT CONTINUED
FIG. 8
FIG. 7
FIG. 6
2
FFHL SLIPFITTER MOUNT WITH FLOOD MOUNT
The Slipfi tter Mount can be mounted on a Round Pole (Ø2 3/8”).
Run the FFHL Cable from the FFHL fi xture and the Slipfi tter Mount
to the Pole and follow the Wiring Diagram provided to properly install
the light fi xture to the Power Supply Cable. Tighten the Slipfi tter
Screws (4) to secure the FFHL fi xture to the Round Pole (Fig. 8).
4
SLIPFITTER
FFHL FIXTURE
ROUND POLE
POWER CABLE
FFHL CABLE
SCREW
Install the Slipfi tter to the Fixture Mount by mating the teeth and
run the Cable through. If needed to tilt the FFHL fi xture simply
rotateand tighten the Socket Head Screw (Fig. 7). Rotate the FFHL
fi xture on the Flood Mount as needed (Refer to Fig. 4).
3
SCREW
SLIPFITTER
FFHL FIXTURE
FIXTURE
MOUNT
Install the Fixture Mount and Flood Mount (Note: The Flood Mount
has mounting holes correct for the Fixture Mount and diff erent from
the Trunnion Mount) on the FFHL fi xture and fasten them together
with the Screws, Washers, and Lockwashers (Fig. 6).
SCREWS
WASHERS
FIXTURE
MOUNT
FFHL FIXTURE
FFHL CABLE
FLOOD MOUNT
SCREWS
Before installing the Slipfi tter Mount remove the Trunnion Mount by
removing the all Screws, Washers, and Lockwashers from the FFHL
fi xture (Fig. 5).
1
FIG. 5
SCREWS
FFHL FIXTURE
TRUNNION
MOUNT
