FALC Series LED Area Light
Installation Guide
Need help? Tech help line:
(800) 988-6386
Email:
Website:
www.paclights.com
Copyright © 2020 PacLights
All Rights Reserved
Note: Instructions are subject to change at any time without notice
02-00041-20423
AC-ALC-TM
Trunnion Mount
AC-ALC-TM
Trunnion Mount
DRILLING TEMPLATE
1.516”
1.375”
0.545”
3.031”
O 1.00”
Ø 0.437”
If the Power Supply Cable is coming from the wall, the Power Supply Cable will
run through the center of the Trunnion Mount. Then, mount the Trunnion Mount onto
the Mounting Surface using the appropriate mounting Bolts.
(Optional) This hole is only
necessary if the power supply
cable will be coming out the wall.
Once the FALC Fixture is properly
secured to the Trunnion Mount, adjust
the fixture to the desired tilt angle and
fasten the Socket Head Screw.
Align the teeth from the
FALC Bracket Mount to the
Trunnion Mount. Use the
Socket Head Screw to fasten
them together. You can
connect the FALC CABLE to
the Power Supply without
using a Junction Box only if
used with a weather proof
connector.
Page 4 of 7
BOLTS
TRUNNION
MOUNT
SOCKET HEAD
SCREW
2
POWER SUPPLY
CABLE
3
5
If the Power Supply Cable is ran from a Conduit, the FALC Cable must be
fed into a Junction Box specific for outdoor applications. All wiring must be done
inside the J-BOX and all cables must be fed through a water proof connector.
4
POWER SUPPLY
CABLE
SCREW
POWER
SUPPLY
CABLE
Clearance holes
on Mounting Surface to
align with Trunnion Mount
hole locations
MOUNTING
SURFACE
TRUNNION
MOUNT
FALC CABLE
FALC
BRACKET
MOUNT
FALC CABLE
J-BOX
FALC FIXTURE
TRUNNION
MOUNT
Drill holes on the
Mounting Surface by
following the Drilling
Template to mount the
Trunnion Mount to the
desired height.
DRILL
HOLES
1
2
9
“Initial Set-up and Optional Controls”
