INSTALLATION GUIDE
FALC/2 Series LED Area Light
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
Page 4 of 4
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL-INST-FALC/2-v0
FIG. 21
OPTIONAL TRUNNION MOUNT
The drilling template for the FALC/2 Trunnion Mount is shown below
(Fig. 18).
1
FIG. 18
FIG. 19
Install the Trunnion Mount to the Surface/Wall while placing
the Power Cable through the Trunnion Mount. Mount with the
appropraite hardware (Fig. 19).
2
POWER CABLE
SURFACE/WALL
TRUNNION
MOUNT
BOLT
WASHER
LOCK WASHER
Install the FALC/2 fi xture to the Trunnion Mount. Slide the fi xture
Cable carefully through the Trunnion Mount. Attach the Fixture
Cable to the Power Cable (Fig. 20).
3
FIG. 20
POWER CABLE
TRUNNION
MOUNT
BOLT
WASHER
LOCK WASHER
FALC/2 FIXTURE
CABLE
SURFACE/WALL
4
The FALC/2 fi xture can be rotated upward by adjusting the Trunnion
Mount angle. Remove the smaller Screws and Nuts and loosen larger
ones at each side. Rotate to set the angle, then fasten the all the
Screws and Nuts to secure the Trunnion Mount in place (Fig. 21).
SCREWS
NUTS
FALC/2 FIXTURE
LOCK WASHER
OPTIONAL HALF GLARE SHIELD
The FALC/2 Half Glare Shield can help to limit light trespass. Align the Half
Glare Shield to the holes near the FALC/2 Lens Base and fasten with the
Screws (Fig. 22).
FIG. 22
SCREWS
FALC/2 FIXTURE
HALF GLARE
SHIELD
OPTIONAL FULL GLARE SHIELD
The FALC/2 Full Glare Shield can help to limit light trespass. Align the Full
Glare Shield to the holes near the FALC/2 Lens Base and fasten with the
Screws (Fig. 23).
FIG. 23
FALC/2 FIXTURE
FULL GLARE
SHIELD
SCREWS
LENS
LENS
SURFACE/WALL
