Packard Bell oneTwo M3350, Руководство по обслуживанию

Страница: 86 / 122

78 Packard Bell oneTwo M3350 / oneTwo M3351 / oneTwo L5350 / oneTwo L5351 Service Guide
Clearing CMOS
You may need to clear the Setup configuration values (CMOS) if the configuration has been corrupted, or if
incorrect settings made in the Setup Utility caused error messages to be unreadable. This procedure will clear
the BIOS supervisor password as well.
Use the JBIOS1 jumper to clear the CMOS data.
• 1-2 position: Normal operation (default)
• 2-3 position: Clear CMOS data
To clear the CMOS data:
1. Turn off the power to the computer and all peripherals.
2. Unplug the power cord from the computer.
3. Unplug the network cable and all connected peripheral devices from the computer.
4. Place the computer on a flat, steady surface with the rear cover facing upward.
5. Reinstall the rear cover by following the procedure described on page 28.
6. Remove the wall mount plate by following the procedure described on page 35.
7. Remove the graphics card by following the procedure described on page 37
8. Remove the hard drive by following the procedure described on page 40.
9. If necessary, remove any other assemblies or cables that prevent access to the CMOS clear jumper.
10. Locate the JBIOS1 jumper on the mainboard.
11. Remove the jumper block and set it over the 2-3 pins for 20 to 30 seconds.
12. Return the jumper block to its default 1-2 position.
13. Reinstall the hard drive, graphics card, and the wall mount plate.
14. Reinstall any any other assemblies or cables that have previously been removed.
15. Reinstall the rear cover and the computer stand.
16. Connect the AC power cord to the system.
17. Press the power button to turn on the computer.
18. During POST, press Delete to access the Setup Utility.
19. Press F9 to load the system default values.
20. Press F10 to save the changes you made and close the Setup Utility.