1616161616
Packard Bell EasyNote MX Disassembly Manual
16
5. Remove the 8 screws securing the LCD and lift out the LCD panel.
Fig. 28 Location of screws securing LCD module.
6. Remove the 4 screws on each side of the bracket.
7. Remove the top support bracket (usually held in place by the left and the right brackets).
8. Disconnect the LCD cable from the back of the panel.
Inverter Board
To remove the inverter board, first remove battery (see
Battery
), the HDD (see
Hard Disk Drive
), the CD-
ROM or DVD drive (see
Optical Disk Drive
), the wireless network card (see
WLAN Card
), the installed
memory (see
Memory
), the CPU (see
Processor
), the keyboard (see
Keyboard
), remove the LCD screen
(see
LCD Screen Assembly
), disassemble the LCD panel
up to step 3
(see
LCD Panel
), and then do the
following:
1. Disconnect all cables from the inverter board (see
Fig. 27
).
2. Remove the screw securing the inverter board (see
Fig. 27
) and extract the board.
Note:
The protective Mylar around the inverter board is a separate service part.
Webcam
To remove the webcam, first remove battery (see
Battery
), the HDD (see
Hard Disk Drive
), the CD-ROM
or DVD drive (see
Optical Disk Drive
), the wireless network card (see
WLAN Card
), the installed memory
(see
Memory
), the CPU (see
Processor
), the keyboard (see
Keyboard
), remove the LCD screen (see
LCD Screen Assembly
), disassemble the LCD panel
up to step 3
(see
LCD Panel
), and then do the
following:
1. Disconnect the cable from the webcam.
Fig. 29 Location of webcam connector.
2. Lift out the webcam.