13
OPERATION
OPERATING
1. Connect the machine connector (1) to the battery connector.
2. Turn the key (2) clockwise to ON. The signal light will come on (3), indicating
the batteries are charged. Note: If the battery indicator is blinking, the batteries
need to be charged.
3. Press the solenoid valve switch (4).
4. Press the vacuum motor switch (5).
5. Press the brush motor switch (6).
6. Adjust the amount of cleaning solution through the lever (1). There should be
enough solution to wet the floor uniformly, but not so much that it gets past the
splash guard. Remember that the correct solution quantity depends on the type
of floor, the dirt and the speed.
7. Release the lever (2) and lower the brush base.
8. Lower the squeegee using lever (3).
9. Make sure the parking brake (4) is released.
10. The machine will move by pushing the lever on the handle bar forward as
described in the next section. During the first few yards of operation, confirm
the amount of cleaning solution is sufficient and that the squeegee dries the floor
surface.
1
MOVEMENT (machines without traction)
The traction of this machine is obtained through the brush, which is slightly inclined
to help drag the machine forward. To move the machine, turn the key (1) ON, wait
for 3 seconds and then push the lever (2) on the handle bar forward.
WARNING!
Lift the squeegee when moving backward.
6
5
4
3
2
1
4
3
2
2
1
