Pacific GENIUS 14, Инструкция по эксплуатации и обслуживанию

Страница: 3 / 12

3
OPERATING PROCEDURES
WARNING! For the safe operation of this
machine follow the instructions given in this
booklet and the training given by your supervi-
sor. Failure to do so can result in personal
injury and/or damage to machine and property!
DO NOT OPERATE MACHINE IN AN
EXPLOSIVE ENVIRONMENT!
WARNING! NEVER USE THIS MACHINE
TO PICK UP VOLATILE OR EXPLOSIVE
MATERIALS.
WARNING! DO NOT PICK UP WET
MATERIAL WITH THIS MACHINE.
The model shown in this manual is intended for commercial
use and for vacuuming dry material only.
ASSEMBLY
To prepare the machine for operation, make sure it is of cor-
rect voltage and properly assembled. If in doubt, ask your
supervisor.
1. Place the brush head on a flat surface and latch the
swivel neck into the upright and locked position.
2. Turn the knob (Drawing 1, Item 57) located on tank
assembly counterclockwise to the right. Insert the tank
assembly over the projection ears on the lower unit while
keeping the tank in the vertical position. Return the knob
to the locked position by turning it clockwise.
3. Attach the flexible hose to the vacuum tank. The
long rigid portion of the flexible hose should be inserted
into the lower portion of the vacuum tank assembly.
OPERATION AS AN UPRIGHT VACUUM
1. Properly install the filter bag in the vacuum:
Depress the two white buttons on the back of the vacuum
housing door (Drawing 1, Item 8), then swing it up and
open. Place the bag into the opening with the notched
portion next to the handle tube.
2. Plug the machine’s power cable into a properly
grounded outlet (see Safety Instructions).
3. Adjust the brush height to suit the thickness of the
carpet. The adjustment ranges from positions 1 through 4:
Position 1 for very low pile carpet and Position 4 for very
high pile carpet. Adjust the height adjustment knob
(Drawing 2, Item 39) to the lowest number position that
results in the green light being on and the red light off
(reference the “Electronic Power Brush Monitor” section).
4. Depress the foot pedal to lower the handle to the
operating position.
5. Turn ON the switch -the vacuum and brush motors
will start. Begin your DRY pick up vacuuming.
OPERATION with ACCESSORIES
1. Properly install the filter bag in the vacuum.
2. Plug the machine’s power cable into a properly
grounded outlet.
3. Remove the rigid portion of the flexible hose from the
lower portion of the vacuum. The brush motor will
automatically stop when the hose is removed.
4. Attach the crevice or dusting tool to the wand, turn
the vacuum ON and begin.
5. Upon completion, reinsert the rigid portion of the
hose into its’ retaining hole.