PREPARATION
This machine is intended for commercial use
WARNING: Machines can cause an explosion when near flammable materials and vapors. Do not use this machine near fuels,
grain dust, solvents, thinners, or other flammable materials. Do not use flammables to clean this machine.
CAUTION: Do not operate the machine without the brush or pad installed
1. Remove obstructions in intended cleaning area prior to operating the machine
2. Verify the facility and the machine have compatible voltage prior to use (see Safety Instructions)
3. Inspect the machine for loose or damaged components
4. Unplug the cord from the wall outlet and lay the machine back to expose the pad driver
5. Select the appropriate pad for the application (scrubbing, finish removal, etc…)
6. Lay the machine on its side and remove the screw in the bottom of the drive adaptor
7. Position the brush or pad on the drive adaptor
8. Assemble the attachment screw and tighten
9. Check the application recommendations and procedures on the cleaning or finish instructions
OPERATION
1. Plug the power cable into a properly grounded outlet (see Safety Instructions)
2. Adjust the handle height to a comfortable position
3. Start the machine by depressing the trigger switch
4. Guide the machine by slightly raising and lowering the handle
a. Raise the handle slightly to go left
b. Lower the handle slightly to go right
5. Release the switch lever to stop the machine
MAINTENANCE
WARNING: Always disconnect the machine’s electrical plug from the electrical outlet before performing any service,
maintenance, pad changing or inspection of the machine.
NOTE:
The motor is lubricated for life under normal use. No oiling or greasing is necessary.
NOTE:
To prevent brush damage and reduce wobble problems, do not store the unit with the machine weight on the
brush. Either remove the brush or support the unit on a hook while in the storage position.
AFTER EACH USE
1. Store the machine in a clean dry area
2. Wipe the entire machine and cord down with a clean cloth
3. Inspect the cord and plug for nicks, cuts or damage
4. Remove the pad or brush and clean thoroughly
WIRING DIAGRAM
3