Instruction Manual
Please read the instructions carefully before installing or starting up your fan. This manual
contains important information on personal and user safety measures to be followed
while installing, using and carrying out maintenance work on the fan. Once the product
has been installed, please hand in this booklet to the end user.
Digital copies of Pacific Ventilation installation manuals are available at www.pacificventilation.com/install
Check that the fan is in
good
condition while unpacking.
If the fan was damaged during transport contact
. Please make sure that the fan coincides with the product you have ordered.
Transport and storage
•
The packaging has been specifically designed to protect the fan under normal transport conditions. It is important to
transport the fan in its original packaging to prevent any deformation or damage to the product.
•
To ensure that the fan is in good condition upon installation, it should be stored in its original packaging, in a dry and
clean place, protected from dust and dirt.
•
If the fan is not in its original packaging or if there are any signs that it has been tampered with or damaged during
delivery, please do not accept the delivery.
•
Avoid placing any heavy objects on the packed product and be careful not to knock or drop it.
Important safety information
•
Only qualified personnel should carry out the installation.
•
Ensure that the installation complies with the relevant standards, regulations, and electrical norms.
•
After installation the fan complies with the following standards
•
Standard for Low Pressure installations 2014/35 EU
•
Standard for Electromagnetic Compatibility 2014/30 EU
•
Do not use the fan in explosive or corrosive environments.
•
If you intend to install the fan to extract air from a space where a boiler or other combustion heater is installed, ensure
that the building has enough air intakes for adequate combustion. The extractor outlet should not be connected to a
duct used for exhausting smoke or fumes from any gas or fuel-powered device.
•
The fan is not suitable for use by children.
Safety during installation
Please ensure that there are no loose items near the fan before running it. These items could be sucked up by the fan
and cause damage. If the fan is being installed in a duct, please ensure that the ducting is free of any debris or objects
that could get sucked up by the fan.
When installing fans, it is important to ensure that all fittings are in place, and that the structure can support the fan’s
weight at full power.
Before installing or wiring the fan, make sure to disconnect the main power supply, even if the fan is switched off. Check
that the mains supply voltage and frequency values match the wiring diagram information.
The electrical installation must include a double pole switch with a contact clearance of at least 3mm and be correctly
sized in accordance with the Australian electrical standards. Please follow the wiring diagram for the electrical
connections.
If an earth connection is necessary, check that it is correctly connected and that adequate thermal and overloading
protection has been connected and adjusted to the corresponding limits.
If the fan is installed in a duct, the ducting must be exclusively for the ventilation system. Make sure there are no loose
items near the fan, as they could run the risk of being sucked up by it. If it is going to be installed in a duct, check that
the ducting is clean of anything that could be sucked up by the fan.
