Pacific Steamex TRIUMPH 430, Инструкция по эксплуатации и обслуживанию

Страница: 2 / 12

INTRODUCTION
The Pacific Steamex Triumph 430 is a fully self-contained, portable carpet extractor system.
The Triumph 430 has a 60 psi solution pump and a two (2) jet spraying system to apply solution to the carpet.
A rotating brush is driven by a cogged belt system at approximately 1000 RPM’s. This brush provides a very aggressive
agitation of the solution into the carpet fibers to loosen ground-in dirt. The chevron pattern of the brush bristles channels the
dirty water to the center of the 12” aluminum vacuum head for better extraction.
The two-stage vacuum motor on the Triumph 430 is capable of 80 inches of water lift. The Triumph 430 extracts virtually all of the
dirty solution from the carpet fibers, which dramatically reduces drying time.
The Triumph 430 is a very “user friendly” machine. All controls are located at the top of the handle grips, literally at your
fingertips. The 430 has a 4 gallon solution tank and a 3 gallon lift out recovery tank.
This machine must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electric current to reduce the
risk of electric shock. This machine is equipped with a cord having an equip-
ment-grounding conductor and grounding plug. The plug must be inserted
into an appropriate outlet that is properly installed and grounded in accor-
dance with all local codes and ordinances.
WARNING - Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified electrician or
service person if you are in doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the machine - if it will not fit the outlet,
have a proper outlet installed by a qualified electrician.
This machine is for use on a nominal 120-volt circuit, and has a grounded
plug that looks like the plug illustrated in figure A. A temporary adapter that
looks like the adapter illustrated in figures B and C may be used to connect
this plug to a 2-pole receptacle as shown in figure B if a properly grounded
outlet is not available. The temporary adapter should be used only until a
properly grounded outlet (figure A) can be installed by a qualified electri-
cian. The green colored rigid ear, lug, or the like extending from the adapter
must be connected to a permanent ground such as a properly grounded outlet
box cover. Whenever the adapter is used, it must be held in place by a metal
screw.
NOTE: In Canada, the use of a temporary adapter is not permitted by the
Canadian Electrical Code
EXTENSION CORDS
Use only three-wire 14/3 or larger gauge approved extension cords that have
three-prong grounding type plugs and three-pole receptacles that accept the
appliance’s plug. Replace or repair any damaged cords or plugs.
When servicing, refer to authorized person only. Use only identical replace-
ment parts.
Grounding Instructions
NOTE: Do not use adapters shown in figures B & C in Canada
2