A pressured RAW WATER WASHDOWN is available from a hose spigot bow and stern. To activate, flip
the PUMP ROCKER SWITCH located on the DC panel. After use, turn the switch off to prevent pump burn
out, and ensure no object leans on the switch to turn it on accidentally.
GALLEY
Stove/oven
The stove and oven is propane. Turn on the “stove” breaker on the AC panel.
Your propane stove is activated by the following steps:
#1 Turn on the propane tank located under bench on fly bridge, port side.
#2 Turn on the DC breaker labeled “propane stove” and the solenoid switch located right of stove.
#3 Turn on the gas at the stove (Press in knob) and light burner. You might need to hold knob in
for a few seconds while the thermo coupler warms up. The same applies to lighting the oven.
When finished cooking turn off the switches and the bottle.
Refrigerator
The REFRIGERATOR is dual voltage (12-volt and 110-volt power). It will automatically use 110-volt
power when the shore power is connected; otherwise, it will operate on 12-volt power. Monitor the use of
the refrigerator when the engines are not charging the 12-volt battery system. The local power switch is
located below the front door. It can be turned down to the lowest position when anchored or moored or
turned off when turning in for the night.
HEATING SYSTEM
Diesel Heater (DC)
The Espar DIESEL FORCED-AIR FURNACE located port side of engine room towards the front provides
heat in the same way as a household furnace. The thermostat and ON/OFF control is located on the left side
of the stair way leading to the state rooms.To activate the heating system, first go to the DC panel and locate
the toggle switch labeled ER SUB PANEL
LEAVE THIS ON AT ALL TIMES!!!!
.
Now go to the
thermostat and turn the switch on to the “O” position. Rotate the black knob to the clockwise until you hear
the heater/boiler start. It will take about 30 minutes to come up to temperature before the fans will begin
circulating heat. You can regulate the level of heat by turning down the thermostat. There are vents (black
and round) located in the Salon, Galley/Pilothouse stairs and the two heads and the forward state room. The
exhaust for the system is under the swim platform on the
Built-in Cabin Heat (AC) Shore power or Generator required
3 ELECTRIC HEATERS are available when connected to shore power. One is located in the master
stateroom stateroom, one is guest stateroom and also in the pilot house. Make sure the heater breaker on the
AC panel is on.
