Page 8
SKU 98444
For technical questions, please call 1-800-444-3353.
basic sPeciFicatiOns
Fuel
Type
86+ octane unleaded
gasoline
Capacity
0.55 Gallons
Engine Oil
Type SAE
10W-30 above 32° F
5W-30 at 32° F or
below
Capacity
0.63 Quarts
Pump Oil
SAE 75W-90 Non-
detergent
Engine Speed for
Pressure Washer
2,000 RPM @ idle
Water Flow
1.6 GPM
Maximum Pressure
2,000 PSI
note:
Additional specifications found in
the TECHNICAL ENGINE SPECIFI-
CATIONS chart in this manual.
note:
The pump arrives from the factory
with oil included (120ml pump oil).
Only qualified service technician
should repair and perform mainte-
nance on the pump.
The emission control system for this
Pressure Washer’s Engine is warranted for
standards set by the U.S. Environmental
Protection Agency. For warranty informa-
tion, refer to the last pages of this manual.
At high altitudes, the engine’s carbu-
retor, governor (if so equipped), and any
other parts that control the fuel-air ratio will
need to be adjusted by a qualified me
-
chanic to allow efficient high-altitude use
and to prevent damage to the engine and
any other devices used with this product.
unPacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
set uP instructiOns
read the entire iMPOrtant
saFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
risk of accidental
starting; resulting
in serious personal injury.
turn the Power switch of the
equipment to its “OFF”
position, wait for the engine to
cool, and unplug the spark
plug wire(s) before
assembling or making any
adjustments to the equipment.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
Slide the Wheel Shaft (12) on the
1.
Wheel Kit through a hole on the bot-
tom of the Base (39) and secure with
the Wheel Shaft Caps (19). Repeat
for other side.
Insert the Handle (1) into the tubes
2.
on the Base and secure with Bolt
(24), Locknuts (25) and Washer (26).
Attach the Hose Hook (38) onto the
3.
right side of the Handle using Bolts
(4), Locknuts (5), and Washers (6).
Attach the Gun Hook (37) onto the
4.
left side of the Handle using Bolts (4),
Locknuts (5), and Washers (6).
warning
REV 08d
