010606-20 VISTA
INSERT-C
7
Surround Assembly and Installation
1) Lay part A, B and C face down on a fl at non-marring
surface. Fasten together with 1/4" x 1/2" bolts and nuts
provided through holes at points “D” (Fig. #8 and 11).
2) Lift the surround assembly to the upright position and
make sure the front face is fl at and even at the joints.
3) Assemble the three trim pieces using the enclosed hardware.
Slide part F into the back corners of the trim and tighten
screws. Ensure the mitred corners fi t tightly and evenly
(Fig. #9).
4) Slide the assembled trim over the surround from the top
(Fig. #8).
5) Tighten the retaining screws at the bottom of each trim
side (Fig. #10).
Fig. # 8
Fig. # 9
Fig. # 11
Fig. # 12
6) DO NOT LIFT THE SURROUND ASSEMBLY BY
GRASPING THE TRIM. Engage the bottom of the pre-
assembled surround onto the unit. The surround base is
notched to fi t over the casing fl ange. (see Fig. #12) Pivot
surround assembly up into place and secure with 2 screws
in the upper corners of the casing. (see Fig. #13)
Part B
Trim
Fig. # 10
Trim
Retaining
Screw
Part F
Part A
Part C
Part A
Trim
D
D
D
1/4" Nuts
Part C
1/4" x 1/2" Long Bolts
Notch in Surround Base
