Pacific energy T5, Инструкция по установке и эксплуатации

Страница: 12 / 24

12
ALT5.CPINSB 180314-24
4) Loosen the two bolts that secure the ash lip to the fi rebox
(Fig #22), carefully lift up the ash lip and remove from the
fi rebox.
5) Loosen the screws on the wire support tabs and turn to remove
the wires (Fig #23).
6) Remove the two screws securing the speed controls assembly
to the ash lip (Fig #24).Remove cover plate on opposite
side.
Fan Speed Controller Relocation
The fan speed controller is factory installed under the ash lip
on the right hand side. If required, it can be relocated to the left
side by following the instructions below. To make this as easy
as possible, it is suggested that this be done prior to fi tting the
surround and installation into the fi replace:
1) Remove the decorative top by tilting up slighty and lifting
away from the unit. (Fig #18)
2) Lift up on each fan shield and remove. Set aside to prevent
damage. (Fig #19)
3) Disconnect the wires from the fans, Left & Right Side(Fig #20).
Unscrew thermal snap switch leaving the wires connected(Fig
#21). Take note of where the wires are routed and secured.
They must be positioned correctly to avoid damage.
`
BOLTS
SCREWS
SCREWS
Fig. # 18
Fig. # 19
Fig. # 20
Fig. # 22
Fig. # 24
Fig. # 23
FAN SHIELD
Fig. # 21
Lift Up