Pacific energy Pacific Wood Insert DESIGN-D, Инструкция по установке и эксплуатации

Страница: 8 / 20

8
300309-20
9) Push the entire appliance back until the surround as-
sembly is in contact with the fireplace.
10) Position the decorative bay stove top onto the firebox
top. Ensure that the studs align with the slotted tabs,
one on each side of the firebox top. Secure in place
with 1/4” nuts provided.
11) Replace the front panels and ashlip in the reverse order
to their removal.
8) Slide pre-assembled surround into the friction fit tabs
on the inside of the outer casing. DO NOT LIFT THE
SURROUND ASSEMBLY BY GRASPING THE TRIM.
The surround is held in place by four screws, two each
side, just inside the casing near the top and bottom.
Push surround back until snug and even. Fasten in
place.
7) Remove the two screws which were concealed by the
ashlip and two screws near the top from the left and right
panels. Remove front panels and set aside to prevent
damage.
Fig. # 10
Fig. # 11
Fig. # 12