Pacific energy G963, Инструкция по установке и эксплуатации

Страница: 22 / 34

22
INSTALLER
INFORMATION
Servicing of the appliance can be performed from the rear of the unit by removing the access panel
from the unit.
Caution : The gas line should be installed by a qualified service person in accordance with all
building codes. This section is intended as a guide for qualified technicians installing this
appliance. Consult local and/or national building codes before proceeding.

Gas supply line connection is located on the rear of the fireplace. Gas connection accepts a
½” 45° flare fitting. Correct gas line diameter must be used to assure proper operation and
pressure.

The fireplace input rating is shown in the chart below.

A drip leg must be installed in the gas supply line going to the gas control valve to -minimize
the possibility of any loose scale or dirt within the gas supply line from -entering the control
valve.

It is essential that a union or flanged connection be installed just upstream of the valve to
allow for repair or replacement of the gas valve.
Check local codes for additional requirements.
Turn on the gas supply and check that all connections are tight and leak free.
WARNING: The gas tray including gasket must be reinstalled after
conversion/installation or servicing has been completed.
Gas Pressure Check
Please refer to following page for gas pressure testing procedure.
Gas Supply
Gas pressure requirements
Input Pressure Natural Gas Propane
Minimum 4.0" WC 11.0" WC
Maximum 13.9" WC 13.9" WC
Manifold Pressure
High 3.5" WC 10" WC
Low 1.6" WC 6.4" WC
G963
Gas Orifice Output AFUE
NG 2.55mm 30,000 btu/hr 70%
LP 1.52mm 28,000 btu/hr 70%