12
FUSION_D1
010604-16
Optional Blower
The optional blower kit (kit #WODC.BLOW) is equipped with
a three prong power cord and may be installed at any time.
Follow installation instructions supplied with the kit. Route
power supply cord away from heater.
Electrical rating: 115 volts A.C.-1.02 amps.
Fan output rating: 125 CFM
Blower Installation
1. Loosen the 2 screws at the center of the blower.
2. Install the temperature snap-switch assembly onto the
blower by placing the bracket over the screws.
3. Tighten the screws.
4. Ensure that the two wires are connected to the temperature
snap-switch.
5. Bend over the blower clearance tab and shown in the
picture.
6. Feed the power cord into the pedestal base and out through
the round hole near the bottom.
7. Slide the temperature snap-switch assembly up into the
space between the rear shield and the firebox, ensuring that
the temperature snap-switch contacts the firebox.
8. Install the two screws through the flange of the blower into
the rear shield.
9. Plug the power supply cord in and check blower operation.
Power Cord
Clearance
Tab
Temperature
Switch
Blower Operation
Proper blower speed matched with air control setting will
ensure peak performance from your stove. Operate as follows:
- Air control set to low (right-most position), operate
blower speed control on "Low".
- Air control set between low and high, operate blower
speed control at desired setting.
Automatic:
To operate the blower automatically, set the
rocker switch on the side of the fan housing to "Auto" and set
the speed control to desired setting. This will allow the fan to
turn on as the stove heats up to operating temperature. It will
also shut the blower off after the fire has gone out and the unit
cooled to below a useful heat output range.
Manual:
To manually operate the blower, set the rocker
switch to "Man" and set the speed control to desired setting.
This will bypass the sensing device and allow full control of the
blower.
Switching from "Auto" to "Man" or selecting speed may be
done anytime.
FIG. #5
FIG. #6