5
Xi3 (PX031ANI) USER GUIDE DRAFT (501-340120x)
W
arranty VOID if Broken or Removed
W
arranty VOID if Broken or Removed
Safety aspects of connections
Full details of the rear panel are on page 6.
Connecting
Do not connect your set-top box (or any other equipment such as a TV or
DVD player) to the power supply until you have properly connected all the
other cables.
Your set-top box is designed for use only with the power supply unit provided.
On the power supply unit there is a label that specifies the correct AC
power supply input for it. Do not connect the power supply unit to any
supply other than this.
Always connect the 5 volt DC cord from the power supply unit to your set-
top box before you insert the AC power cord from the power supply unit
into the wall AC outlet.
Disconnecting
To disconnect power from your set-top box, always detach the power
supply unit from the wall AC outlet (rather than remove the 5 volt cord
from your set-top box).
Therefore you must install your set-top box near to the wall AC outlet,
which should be easily accessible.
If you are in any doubt about the power supply cord, its plug or its
connection, or are not certain that the electrical outlets you are using
are properly wired and grounded, consult a qualified electrician before
proceeding any further.
SAFETY INFORMATION (cont.)
The
Cable In
connector is designed for
connection to a cable network only.
You must not connect any other
equipment, such as a VCR, to this input.
Power Input
Regulatory information
CAUTION:
• Do not attempt to modify your set-top box without written
authorization from the manufacturer. Unauthorized
modification could void your authority to operate your set-
top box.
• Failure to heed the Safety Information provided by
failing to connect to a properly wired outlet may void the
manufacturer’s warranty.
NOTE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. This
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC RF Radiation Exposure Statement
MPE/SAR/RF Exposure Information.
This equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment.
This equipment was verified for RF exposure and found to comply with
Council Recommendation 1999/519/EC and FCC OET-65 RF exposure
requirements.
WARNING:
While this equipment is in operation, a separation distance
of at least 20 centimetres (equal to 8 inches) must be maintained
between the antenna inside the equipment and the bodies of all
persons exposed to the antenna in order to meet the FCC RF exposure
guidelines. Making changes to the antenna or the equipment is not
permitted. Doing so may result in the equipment exceeding the FCC
RF exposure guidelines. This equipment must not be co-located or
operated in conjunction with any other antenna or radio transmitter.
5 volt power
supply unit
To ensure correct operation, use this set-top box only with the Pace-approved
power supply unit provided. If you use an unapproved alternative, you will
invalidate the warranty.
