PACE Sodr-X-Tractor Handpiece
©2012 PACE Inc., Southern Pines, NC. All Rights Reserved
Page 4 of 11
www.paceworldwide.com
Handpiece Setup
Connect the handpiece connector plug into one of the Power Receptacles on
your PACE power source in the following manner.
1. Align guide on connector with slot on power receptacle.
2. Insert connector into power receptacle.
3.
Turn the connector housing clockwise to lock in place.
Vacuum Hose Connection
To set up your Sodr-X-Tractor vacuum hose connection, perform the following steps:
1. Vacuum Hose To Handpiece Connection
a) Attach one end of a 137cm (54 inch) length of air hose to the metal tube in the back of the handpiece.
b) If you have a PACE system incorporating only one handpiece, attach the air hose to the SX-handpiece
power cable using the supplied Hose Clamps. Space them evenly along the length of the power cable
starting at a point 6 inches from the ends of the handpiece.
c) If you have a PACE system incorporating 2 or more air handpieces (e.g., SX-90/80,TP-100, TJ-70, TP-65),
you may wish to leave the air hose assembly unattached to allow a quick change to any air handpiece being
used.
2. Prepare a VisiFilter in the following manner:
a) Connect a 1-inch (2.5cm) length of clear PVC air hose to the
FLOW OUT side of the VisiFilter; push and turn the hose onto
the VisiFilter nipple to seat.
b) Insert the ribbed end of a male quick connect hose mount
fitting (P/N 1259-0087) into the free end of the 1 inch (2.5cm)
length of air hose connected to the FLOW OUT side of the
VisiFilter.
c) Connect the free end of the 137cm (54 inch) length of air
hose to the FLOW IN side of the VisiFilter.
d) Insert the end of the quick connect hose mount fitting (on
VisiFilter FLOW OUT side) into the power source Vacuum
Port.
3. When using air pressure, and/or utilizing multiple air handpieces,
PACE recommends the use of the following set up procedure which utilizes additional quick connect hose
mount fittings. An assortment of quick connect air fittings are supplied with each additional air handpiece.
NOTE
Insure that only one air handpiece is connected to either the
Vacuum Port
or
Controllable
PRESSURE
Port at one time. Attachment to both ports
simultaneously will cause a deterioration of performance.
