Temperature Setback Operation
OPERATION
1.
Temperature Setback for each channel is indicated by the following.
a)
The Current Channel LED will flash off once every 2 seconds when that channel is in Temperature
Setback Mode.
b)
Any Active, non-Current Channel LED will flash on once every 2 seconds when that channel is in
Temperature Setback Mode.
2.
Any Inactive Channel will not enter Temperature Setback Mode.
3.
Any Active Channel whose Set Tip Temperature is less than 180°C (350°F) will enter Temperature
Setback Mode but will remain at its original Set Tip Temperature.
EXITING TEMPERATURE SETBACK MODE
Listed below are 4 different ways to exit Temperature Setback Mode.
1.
For any individual channel, perform the following operation.
a)
Press and release the CH SELECT Key until the Setback Channel becomes the Current Channel
shown on the Digital Readout.
b)
Press and release the Scroll Up Key.
c)
The system will now restore the previous Set Tip Temperature.
d)
Observe the Digital Readout as the Operating Tip Temperature increases to the Set Tip Temperature
(if above 180°C (350°F)). For optimum performance, do not attempt to use the attached handpiece
until set temperature is achieved.
45
