©2012 PACE Inc., Vass, North Carolina, All Rights Reserved
Page 4
Operation
1. Remove Arm-Evac 105 from packaging and place in suitable position.
2. Plug the supplied power cord into receptacle at left side of unit, ensuring that it is connected to a
properly grounded outlet.
3. Fit appropriate fume collection accessories.
4. Turn on the Arm-Evac 105.
Maintenance
Fuses:
The fuse is located in a sliding tray at the left side of the unit, just below the power receptacle.
Each Arm-Evac is supplied with one replacement fuse, also located in the sliding tray.
Fan Assy:
The Arm-Evac 105 is fitted with a brush-less, single inlet fan assembly, which does not require
routine maintenance. It is important that fume extractor filters are changed on a regular basis to
protect the fan assembly.
A vent is located on the right side of the unit to allow the cleaned air to return to the workplace.
Do not cover this vent as this may cause damage to the fan assembly.
Never operate the Arm-Evac 105 without filters installed.
Troubleshooting
Symptom
Possible Causes
Solution
System will not turn on.
No power supplied to unit
Make sure the power cord is fully seated and
that the power is turned on.
Reduced Airflow
Filter blocked.
Check & change filter(s)
Arm attachment not installed correctly.
Make sure all accessories are fully seated.
If the unit does not work after checking the above, please contact PACE, or your Authorized PACE Distributor if
outside U.S.
