Paccar TX-18, Руководство оператора

Страница: 57 / 72

• Small container (to catch fluid)
• Standard wrench
• Torque Wrench
• 8mm hex bit socket
Perform this procedure with the
transmission installed in the vehicle.
CAUTION
DO NOT operate the transmission at
an operating angle greater than 12°
(approximately 21% road grade). The
operating angle is the transmission
mounting angle plus the road grade
expressed as an angle. Failure to
comply will result in improper transmis-
sion lubrication and may result in
equipment or property damage.
1. Park vehicle on a level surface with
the transmission in neutral, engage
the parking brake, and chock the
tires.
2. Turn off the engine after it has idled
for two minutes.
10
3. Locate the check plug (1) and
place container under the check
plug hole.
11
4. Remove the check plug using
wrench.
5. Observe the check plug hole:
a. If a small amount of fluid runs
out of the check plug hole,
there is sufficient transmission
fluid.
b. IF NO fluid runs out of the
check plug hole, STOP.
Replace check plug and add
fluid to the transmission (see
Adding Transmission Fluid on
page 55).
6. Inspect the check plug and O-ring
for damage. If damaged, replace
with new plug and O-ring.
7. Insert the check plug with O-ring,
and torque plug to 37-43 N·m
(27.3-31.7 lb-ft).
NOTE
Do not over-torque the check plug or
transmission damage may occur.
Adding Transmission Fluid
1
2
10
Idling the engine places oil temperature in the required range for this procedure: 60° F – 120° F (15.5° C – 48.8° C).
11
Check plug can be accessed beneath the cab, driver side.
MAINTENANCE - Lubrication
Y53-1349-1A1 (02/2022) 55
6