SWI-X
SWI-X
SWI-X
SWI
Programming the SWI-X to Control the Head Unit (cont.)
Step 21.
Release the VOLUME UP button.
Right LED will turn on.
Step 22.
Hold the IR emitter on the head
unit’s remote control within 3 to 4
inches of the IR Input on the SWI-
X. Press and hold the VOLUME
UP button on the remote control.
Right LED will turn off.
Step 23.
Release the VOLUME UP button
on the remote control.
Left LED will turn on.
The function is pro-
grammed.
Step 24.
Repeat steps 20 - 23 for each audio function on the steer-
ing wheel control. Press the corresponding function on the
head unit’s remote control.
Wait no more than 7 seconds
between programming each function
, or the SWI-X will
exit the programming mode and the procedure must be
restarted (Step 11).
Note:
If the steering wheel control has a function that the
head unit remote control does not have, you can program
the steering wheel function to operate any other command
on the head unit remote control.
Once programming
is completed, LEDs
will flash three times
after 7 seconds. The
Interface will then flash
the version #.
Testing the SWI-X
Final Installation
Hold the SWI-X infrared emitter (clear blue light at the end
of the four-foot wire) close to the head unit and test each
function of the steering wheel controls. The right LED on
the SWI-X will flash indicating it is sending an IR command
when each button on the steering wheel is pressed. If
any function does not work, repeat the programming
instructions (starting from Step 11) or refer to
Appendix F
- Troubleshooting Guide
(page 8).
Mount the SWI-X infrared emitter within line of sight of the
head unit, testing continuously to ensure that it will operate
from the chosen position. Install using the supplied bezel,
installing the bezel and mounting the emitter from behind.
Complete the head unit and SWI-X module installation.
VOL
SWI-X
SWI-X
VOL
TEMP