J1850
Class 2
VPW
Class 2
J1850
1 0 0 0 1 1 1 0 1 1 1 1 0 0 1 0 0 1 1 0 1 1 0 0
1 1 1 0 1 0 0 0 0 1 1 0 1 1 0 1 1 1 0 0 1 1 0 0
Arbitration
EOD
CRC
1 0 0 0 1 1 1 0 1 1 1 1 0 0 1 0 0 1 1 0 1 1 0 0
1 1 1 0 1 0 0 0 0 1 1 0 1 1 0 1 1 1 0 0 1 1 0 0
Class 2
Class 2
J1850
DISCLAIMER: Under no circumstances shall the manufacture or the distributors of the NU-CHY1 be held liable for claims of any
loss or damage, consequential, direct or indirect, arising from the sale, installation, or use of the NU-CHY1. The manufacture
and its distributors will not, nor will they authorize any representative or any other individual, to assume obligation or liability in
relation to the NU-CHY1 other than its replacement.
AGREEMENT: End user agrees to use this product in compliance with the instructions and terms of use above and with all State
and Federal laws. PAC provides instructions and safety warnings with respect to this product and disclaims all liability for any use
not in conformity with those instructions or other misuse of its product. If you do not agree, please discontinue use immediately
and return product to place of purchase. This product is intended for off-road use and passenger use only.
Operation - Vehicles Without Steering Wheel Controls
Activating the Navigation Unlock
Start with the factory radio on. Turn the radio off then on within three
seconds. The dash mount LED will illuminate red. Turn the radio off then
on again within three seconds to acknowledge “safe use”,
agreeing
that use will be performed only by the passenger whenever
the vehicle is in motion
, and activate the NU-CHY1. The dash
mount LED will then illuminate green. To de-activate the NU-CHY1
simply turn the radio off then on within three seconds.
WARNING:
In order to avoid distraction, which could lead to an
accident, the driver should never utilize systems unlocked by the
NU-CHY1 when the vehicle is in motion. Even when operated by
the passenger, the vehicle driver should maintain their attention on
the road at all times.
LOAD
MENU
AUDIO
PULL
AUX
HARD DISC DRIVE
.1t8."t+1&(
VOLUME
MEDIA
RADIO
PUSH ON
RBZ
MY
FILES
1. Start with radio on.
2. Turn the radio off then on within 3 seconds.
The dashmount LED will illuminate red.
3. Turn the radio off then on again to confirm
safe use. The dash mount LED will illuminate green.
4. Repeat step 2 to de-activate.
Turn radio off and on
within 3 seconds to
activate/de-activate
the NU-CHY2
1. When installing this interface the vehicle must be turned off.
2. If the factory radio does not come on or “flickers” off & on, the factory amplifier does not turn on or you are receiving audio on only one side of
the vehicle, please make sure that the male pins in the NU-CHY1 plug are not bent or out of place.
3. The red status LED on the NU-CHY1 indicates that the board is functioning properly. This LED can only be seen by removing the blue housing
and accessing the main circuit board.
4. In order to see the text on the MFD it must be in the default display of the temperature/compass or at the top of the list if setup in list format.
Installation Notes/Troubleshooting