GM1A-RT
Radio Replacement Interface with
Telematics Retention
for select General Motors Vehicles
with Class II Data-Bus
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Rev: V
6
Date: 0
927
18
Page 4
RadioPRO PC App
Infotainment/Factory Amplifier Adjustments
The RadioPRO app will also allow you to adjust the settings of the factory amplifier (Y91 Premium systems only). You can
adjust Amp Gain, Fader, Balance, Bass, Mid and Treble and real time fade. When real time fade is enabled in amplified
systems, it will allow fading to be controlled directly from the aftermarket radio. Restoring factory settings on the module will
default all values back to middle.
Telematics Volume
You can adjust the OnStar volume through the RadioPRO app. Press the blue button on the mirror or the VR SWC to launch
OnStar then adjust the volume using the slider.
Chime Volume
You can adjust the chime volume through the RadioPRO PC app. Not available in Premium Bose (Y91 / UQA) systems.
Rear Seat Entertainment (RSE); If equipped
The factory RSE system will function independently from the aftermarket radio. The unit will power up and pass audio through
the headphones as long as the vehicle’s ignition is on. If you wish to pass audio from the RSE to the aftermarket radio you must
connect the RCAs from the 12-pin connector to the aftermarket radio’s auxiliary input. Select the aftermarket radio’s auxiliary input
to hear RSE audio.
SWC Re-calibration Procedure (Corvette Only)
Please Note: This is only necessary if after installation, the SWC are acting erratic or
unresponsive in the Corvette.
1. Turn the key to the ignition position.
2. Press and hold the programming button until LED 1 turns amber and you hear two chimes.
When this happens, release the programming button.
3. Within 7 seconds, press and hold the button that is to be learned on the steering wheel.
The LED will turn off when the button is pressed and begin blinking when the value has
been learned. Once the LED begins blinking, release the button.
4. Repeat step 3 for each additional function on the steering wheel.
5. If you come to a button in the list that your vehicle does not have, skip it by pressing the
programming button on the interface. Any buttons not learned during this process will not
function.
6.
Once programming is completed, the LED will flash indicating end of programming.
7. Test the interface for proper functionality. Whenever a SWC is pressed LED 1 on the
interface should blink green. If any function does not work, repeat the programming steps.
Button Programming Order
Volume Up
Volume Down
Seek Up
Seek Down
Preset
Answer / Voice
Hang Up
Preset Up
Download the RadioPRO PC App at: https://aampglobal.
com/radioproapp
Use of the RadioPRO PC App allows you to do
the following:
•
Configure User Interface Options such as:
•
Factory amplifier settings (Bass, Mid, Treble, Gain,
Fader and Balance)
• Chime Volume
• Camera Settings
• Telematics Volume
• Update Product Firmware
• Read Firmware/Hardware Versions
PLEASE NOTE:
The interface must be connected to the vehicle when
using the following features of the RadioPRO PC App:
•
Factory Amplifier Settings
• Chime Volume
• Telematics Volume
The interface does not need to be connected to the
vehicle when using the following features of the
RadioPRO PC App:
• Interface User Options
• Camera Settings
• Firmware Updates
•
Reading firmware/hardware versions